SPAX Stick Pro – Invisible Patio mounting Including Screws for Approx. 1 m2 Terrace, 40 Pieces – 5009422556609

Spax Stick Pro for concealed fixing for decking on wood and aluminium - the invisible Spax Stick Pro connector ensures a flawless look. Easy and safe installation is guaranteed. The matching cylinder head screws are included in the package. How does it work? Screw the first board from below (e.g. with an angle screwdriver) or alternatively visible screws. 2 Spax sticks per substructure are attached to the back of the floor. The board is then reversed and pushed to the already screwed plank. The front Spax stick is pushed under the last plank. Then the Spax sticks are screwed onto the substructure. With the next board is done the same. The middle bridge serves as a stop when putting on and screwing on the sticks on the board. When tightening the decking to adjust the joint width, use the Spax spacer (joint gauge). Additional advantage: the Spax Stick Pro acts like a ventilation bar (similar to Spax Air). This prevents waterlogging on the board edges and allows the board to dry underneath. Instructions for use: suitable for wooden boards up to max. 25 mm thickness – suitable for: Douglas fir, pine, European larch, oak, garappa, bangkirai, Ipe (max. 21 x 130 mm), thermal wood (where applicable. Please note the manufacturer's specifications). Not suitable for: Siberian larch, Cumaru, Bongossi, Massaranduba, wood composite boards (WPC). For very hard import woods, pre-drilling of diameter 3 mm is recommended. Substructure max. every 40 cm. Please note the attached installation instructions (English language not guaranteed). Box contents: 40 x Spax stick pro, 25 x Spax cylinder head stainless steel A2 black 4.5 x 28 mm, 80 x Spax cylinder head Wirox 4.5 x 22 mm, 1 x bit Spax T-Star plus T20 length 50 mm.

• Use: for patio construction for concealed mounting of wooden boards on wood and aluminium. New design for higher load capacity and more stability.
• Board thickness: thickness of decking min. 20 mm and max. 25 mm, board width for tropical wood max. 130mm
• Easy to install: for aluminium substructure: 3 mm wall thickness for coniferous boards and 4 mm for hardwood boards. Handle box is enough for approx. 1m2
• Suitable for: Douglasie, Pine, European Larch, Oak, Garappa, Bangkirai, Ipe (max. 21 x 130 mm), thermal wood (if necessary Observe the manufacturer's specifications).
• Box contents: 40 x Spax stick pro, 25 x Spax cylinder head stainless steel A2 black 4.5 x 28 mm, 80 x Spax cylinder head Wirox 4.5 x 22 mm, 1 x bit Spax T-Star plus T20 length 50 mm, delivered in a handle box